Pro/EngineerM

Case Study Gallery: Pro/ENGINEER

Flask model created at the Rapid Prototyping & Tooling Centre at Ngee Ann Polytechnic in Singapore

Courtesy of Ngee Ann Polytechnic

A photo of the flask

"The flask was first positioned securely on the table. Several vertical lines were drawn, then digitized. The digitized curves were then used to generate the surface.

Rhino software works well with Pro/ENGINEER by exporting the model as an IGES file and then reading it in Pro/ENGINEER. This process saves a lot of time in generating complex curves and surfaces for use in Pro/ENGINEER."

The wireframe in Rhino 3D	The flask rendered in Rhino 3D
The flask in Pro/ENGINEE